Bridge Mode - ZyXEL Communications VMG1312-B10C User Manual

Chapter 5 Broadband
Table 7 Routing Mode (continued)
LABEL
VLAN
Active
802.1p
802.1q
QoS
Rate Limit
MTU
MTU Size
Apply
Cancel

5.2.1.2 Bridge Mode

Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon
next to the connection you want to configure. Select Bridge as the encapsulation mode. The screen
varies depending on the interface type you select.
If you select ADSL/VDSL over PTM as the interface type, the following screen appears.
Figure 20 Bridge Mode (ADSL/VDSL over PTM)
48
DESCRIPTION
These fields appear when the Type is set to ADSL/VDSL over PTM.
Select this option to add the VLAN tag (specified below) to the outgoing traffic through this
connection.
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame
that contains bits to define class of service.
Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection.
The greater the number, the higher the priority level.
Type the VLAN ID number (from 1 to 4094) for traffic through this connection.
Enter the rate limit for the connection. This is the maximum transmission rate allowed for
traffic on this connection.
Enter the MTU (Maximum Transfer Unit) size for this traffic.
Click Apply to save your changes back to the Device.
Click Cancel to exit this screen without saving.
VMG1312-B10C User's Guide