Remote Management And Nat; System Timeout; Remote Management Screens; Www Screen - ZyXEL Communications P-2302R-P1 Series User Manual

P-2302R-P1 Series User's Guide

16.1.2 Remote Management and NAT

When NAT is enabled:
• Use the ZyXEL Device's WAN IP address when configuring from the WAN.
• Use the ZyXEL Device's LAN IP address when configuring from the LAN.

16.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The ZyXEL Device automatically logs you out if the management session remains idle for
longer than this timeout period. The management session does not time out when a statistics
screen is polling. You can change the timeout period in the SYSTEM General screen.

16.2 Remote Management Screens

16.2.1 WWW Screen

Use this screen to control HTTP access to your ZyXEL Device. To access this screen, click
Management > Remote MGMT > WWW.
Figure 82 Management > Remote MGMT > WWW
Each field is described in the following table.
Table 73 Management > Remote MGMT > WWW
LABEL
Server Port
Server Access
Secured Client IP
Address
176
DESCRIPTION
Enter the port number this service can use to access the ZyXEL Device. The
computer must use the same port number.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Select Selected to only allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
Chapter 16 Remote MGMT