Figure 46 Network > Lan > Advanced; Table 40 Network > Lan > Advanced - ZyXEL Communications P-2302R-P1 Series User Manual

P-2302R-P1 Series User's Guide
Figure 46 Network > LAN > Advanced
Each field is described in the following table.
Table 40 Network > LAN > Advanced
LABEL
RIP & Multicast
Setup
RIP Direction
RIP Version
Multicast
Any IP Setup
Active
Windows
Networking
104
DESCRIPTION
Use this field to control how much routing information the ZyXEL Device sends and
receives on the subnet.
None - The ZyXEL Device does not send or receive routing information on the
subnet.
Both - The ZyXEL Device sends and receives routing information on the subnet.
In Only - The ZyXEL Device only receives routing information on the subnet.
Out Only - The ZyXEL Device only sends routing information on the subnet.
Select which version of RIP the ZyXEL Device uses when it sends or receives
information on the subnet.
RIP-1 - The ZyXEL Device uses RIPv1 to exchange routing information.
RIP-2B - The ZyXEL Device broadcasts RIPv2 to exchange routing information.
RIP-2M - The ZyXEL Device multicasts RIPv2 to exchange routing information.
You do not have to enable multicasting to use RIP-2M. (See RIP Version.)
Select which version of IGMP the ZyXEL Device uses to support multicasting on
the LAN. Multicasting sends packets to some computers on the LAN and is an
alternative to unicasting (sending packets to one computer) and broadcasting
(sending packets to every computer).
None - The ZyXEL Device does not support multicasting.
IGMP-v1 - The ZyXEL Device supports IGMP version 1.
IGMP-v2 - The ZyXEL Device supports IGMP version 2.
Multicasting can improve overall network performance. However, it requires extra
processing and generates more network traffic. In addition, other computers on the
LAN have to support the same version of IGMP.
Select this if you want to let computers on different subnets use the ZyXEL Device.
NetBIOS over TCP/IP
Chapter 7 LAN