Resetting The Product To Default Setting; Deleting The Admin Account; Firmware Update; Carry Out A Manual Firmware Update - SMA DATA MANAGER M Operating Manual

SMA Solar Technology AG
8.5

Resetting the product to default setting

Loss of data due to replacement or due to resetting to default settings
If the product is reset to the default settings or replaced, all data saved in the product and the
admin account will be deleted. Some of the data saved in Sunny Portal can be transmitted to
the product after calling up the Sunny Portal system again.
Requirements:
☐ The user interface must be open and you must be logged in.
Procedure:
1. Select the product in the focus navigation.
2. Select the menu Configuration.
3. Select the menu item Device properties.
4. Select the button [If you want to reset the device to the default settings, click here].
5. Select [Reset].
8.6

Deleting the Admin Account

In case the password gets lost, the admin account can be reset and newly created. All system data
will be retained.
Requirements:
☐ The login page of the user interface must be open.
Procedure:
1. Select the [Delete admin account?] button.
2. Enter the device key from the device label.
3. Select [Delete].
☑ The product is performing a restart. Then a new admin account can be created.
Also see:
• Device Key (DEV KEY) ⇒ page 24
8.7

Firmware Update

8.7.1

Carry out a manual firmware update

Functional limitations during the update
While an update is being performed, the functions of the product may be limited. The product
is performing a restart and may be without function at times. This process takes several minutes
and cannot be canceled.
Operating manual
8 Operation
EDMM-20-BE-en-10 61