Removing A Usb Embedded Hypervisor Flash Device; Installing A Usb Embedded Hypervisor Flash Device - Lenovo ThinkServer TS200 Installation And User Manual

10. Replace the hard disk drive fan assembly:
11. Reconnect the hard disk drive fan assembly cable to the system board.
12. Rotate the drive cage back into the server until it stops; then, press and hold
13. Reinstall the hard disk drives.
14. Replace the side cover (see "Installing the side cover" on page 33). Go to
15. Lock the side cover.
16. Reconnect the external cables and power cords; then, turn on the attached

Removing a USB embedded hypervisor flash device

To remove the virtual media key, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Unlock and remove the side cover (see "Removing the side cover" on page 32).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward each
5. Grasp the flash device and pull to remove it from the connector.
6. Press down on the retaining latch to return it to the original position.
7. If you are instructed to return the flash device, follow all packaging instructions,

Installing a USB embedded hypervisor flash device

To install the virtual media key, complete the following steps:
9. Take the other end of the signal cable that is attached to the drive backplane
section for drive bays 0 through 3 (as labeled on the front of the drive cage)
and connect it to the connector that is closest to the battery on the PCI card.
a. Insert the hard disk drive fan assembly retaining tab over the right edge of
the hard disk drive backplane; then, rotate the hard disk drive fan assembly
toward the backplane. Do not fully close the hard disk drive fan assembly.
b. Route the signal cables and power cable through the slot on the edge of
the hard disk drive fan assembly. Make sure that the cables will not be
pinched between the hard disk drive fan assembly and the hard disk drive
backplane when the assembly is installed.
c. Rotate the hard disk drive fan assembly toward the backplane until the
release tabs are fully engaged and snap into place.
the retaining tab on top of the drive cage while you rotate the drive cage into
the chassis until it is in the closed position.
Note: Before you continue, check all internal power cables to make sure that
they are connected to the system board and other optional devices.
"Completing the installation" on page 67.
devices and turn on the server.
on page 29.
other. Then, lift up the bracket cover.
and use any packaging materials for shipping that are supplied to you.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 29.
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see "Removing the side cover" on page
32).
4. Unlock the USB retaining latch by squeezing the two retaining clips toward
each other.
Chapter 5. Installing and replacing optional devices
61