Removing An Optional Serveraid-Mr10Is Vault Sas/Sata Controller; Installing An Optional Serveraid-Mr10Is Vault Sas/Sata Controller - Lenovo ThinkServer TS200 Installation And User Manual

7. Press the ServeRAID-MR10i adapter firmly into the connector on the system
8. Reconnect the cables to the new ServeRAID-MR10i adapter.

Removing an optional ServeRAID-MR10is VAULT SAS/SATA controller

To remove a ServeRAID-MR10is SAS/SATA adapter, complete the following steps:
1. Read the safety information beginning on page vii, and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Rotate the rear adapter-retention bracket to the open (unlocked) position.
4. Open the rear retention bracket.
5. Disconnect any cables connected to the adapter.
6. Carefully grasp the end of the ServeRAID adapter and pull it out of the
7. If you are instructed to return the adapter, follow all packaging instructions, and

Installing an optional ServeRAID-MR10is VAULT SAS/SATA Controller

The optional IBM ServeRAID-MR10is VAULT SAS/SATA controller can be installed
in either PCI slot 1 or slot 2 on the system board. The ServeRAID-MR10is adapter
is supported on hot-swap server models only. The erveRAID-MR10is SAS/SATA
adapter with an encryption 1078 DE chip set enables integrated RAID levels 0, 1, 5,
6, and 10 support capability on hot-swap hard disk drives. For configuration
information, see the documentation on the ServeRAID CD that comes with the
adapter.
Important: To ensure that any of your ServeRAID 10i, 10is, or 10M adapters
function properly on UEFI-based servers, make sure that the adapter firmware level
is updated to at least 11.xx-XXX, and the supporting drivers.
Attention:
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code.
To install the optional ServeRAID-MR10is SAS/SATA adapter, complete the
following steps:
94
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide
board.
on page 29.
all external cables. Remove the side cover (see "Removing the side cover" on
page 32).
Attention: To avoid breaking the retaining clips or damaging the
ServeRAID-MR10is adapter connector, open and close the clips gently.
connector.
use any packaging materials for shipping that are supplied to you.
Some cluster solutions require specific code levels or coordinated code
1. Read the safety information beginning on page vii, and "Installation guidelines"
on page 29.
2. Touch the static-protective package containing the ServeRAID-MR10is adapter
to any unpainted metal surface on the server. Then, remove the
ServeRAID-MR10is adapter from the package.
3. If the battery pack (battery carrier and battery) did not come installed on the
ServeRAID adapter, install the battery pack.
a. Align the battery carrier pins and the connector for the battery carrier with
the pin holes and connector on the ServeRAID adapter; then, lower the
battery carrier onto the ServeRAID adapter.