Removing The Battery; Installing The Battery - Lenovo ThinkServer TS200 Installation And User Manual

2. Install the four screws that secure the power-supply cage to the chassis.
3. Connect the cables from the power-supply cage to the system board and all
4. Reinstall both hot-swap power supplies (see "Removing the hot-swap power
5. Install the side cover (see "Installing the side cover" on page 33).
6. Lock the side cover if you unlocked it during removal.
7. Reconnect the external cables and power cords; then, turn on the attached

Removing the battery

To remove the battery, do the following:
1. Read the safety information that begins on page vii and "Handling
2. Turn off the server and all attached devices.
3. Disconnect all external cables and power cords.
4. Turn the server on its side so that it is lying flat, with the side cover facing up.
5. Unlock and remove the left-side cover (see "Removing the side cover" on page
6. Locate the battery on the system board (see "System-board internal connectors"
7. Remove the battery:
8. Dispose of the battery as required by local ordinances or regulations.

Installing the battery

The following notes describe information that you must consider when you replace
the battery in the server:
v You must replace the battery with a lithium battery of the same type from the
v After you replace the battery, you must reconfigure the server and reset the
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
internal components (see "System-board internal connectors" on page 19 for the
locations of the internal connectors).
supply cage" on page 87).
devices and turn on the server.
static-sensitive devices" on page 31.
32).
on page 19).
a. Use one finger to push the battery horizontally out of its socket, pushing it
away from the socket.
b. Lift and remove the battery from the socket.
same manufacturer.
system date and time.
Chapter 6. Installing and replacing customer replaceable units
89