Installing The Hot-Swap Power Supply Cage - Lenovo ThinkServer TS200 Installation And User Manual

5. Disconnect the cables from the power-supply cage to the system board and all
6. Remove the four black screws that secure the power-supply cage to the
7. If you are instructed to return the power-supply cage, follow all packaging

Installing the hot-swap power supply cage

This procedure applies only to server models that have hot-swap power-supplies.
To install the hot-swap power supply cage, complete the following steps:
1. Place the power-supply cage into the chassis and slide it toward the rear of the
88
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide
internal components.
chassis; then, slide the cage toward the front of the server to disengage the
retaining clips 1 from the top of the chassis and lift the cage out of the
chassis.
instructions, and use any packaging materials for shipping that are supplied to
you.
server until the retaining clips 1 engage the top of the chassis.