Removing A Hot-Swap Hard Disk Drive - Lenovo ThinkServer TS200 Installation And User Manual

10. Remove the EMC filler.
11. Push the drive into the bay.
12. Connect one end of the applicable signal cable into the rear of the drive and
13. Route the signal cable so that it does not block the airflow to the rear of the
14. If you have another drive to install or remove, do so now.
15. Connect the power cable to the rear of the drive. The connectors are keyed

Removing a hot-swap hard disk drive

This procedure applies only to server models that have hot-swap hard disk drives.
Attention:
than 10 minutes without either a drive or a filler panel installed in each drive bay.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
9. Remove the drive retainer clip from the side of the drive cage of bay 1 or bay
2. Slide the drive retainer clip to the front to remove it from the drive cage;
then, snap the drive retainer clip into the screw holes on the side of the drive.
1
EMC shield
2
Tape drive
3
Drive retainer clip
Note: A tape drive can be installed in bay 1 or bay 2
make sure that the other end of this cable is connected into the applicable
connector on the system board.
drives or over the microprocessor and dual inline memory modules (DIMMs).
and can be inserted only one way.
To maintain proper system cooling, do not operate the server for more
Chapter 5. Installing and replacing optional devices
49