Installing The Upper Bezel; Removing A Memory Module - Lenovo ThinkServer TS200 Installation And User Manual

2. Rotate the top of the lower bezel up to the chassis; then, press the blue release
3. Reconnect the external cables and power cords; then, turn on the attached

Installing the upper bezel

To install the upper bezel, complete the following steps:
1. Insert the two tabs on the right-side of the upper bezel into the corresponding
2. Rotate the upper bezel to the left side of the chassis until the bezel clips are
3. Install the lower bezel (see "Installing the lower bezel" on page 36).
4. Install the side cover (see "Installing the side cover" on page 33).
5. Lock the side cover.
6. Reconnect the external cables and power cords; then, turn on the attached

Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords.
3. Unlock and remove the side cover (see "Removing the side cover" on page 32).
4. Locate the DIMM connector that contains the DIMM that is to be replaced (see
5. Carefully open the retaining clips on each end 2 of the DIMM connector and
tab on the right side of the lower bezel and completely close the lower bezel
until it locks securely into place.
devices and turn on the server.
holes on the right side of the chassis.
aligned with the corresponding indentations on the left side of the chassis and it
snaps into place.
devices and turn on the server.
on page 29.
"System-board internal connectors" on page 19 for DIMM slot locations).
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
remove the DIMM 1 .
Chapter 5. Installing and replacing optional devices
37