Removing A Simple-Swap Hard Disk Drive - Lenovo ThinkServer TS200 Installation And User Manual

Removing a simple-swap hard disk drive

This procedure applies only to server models that have simple-swap SATA hard disk
drives.
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Remove the lower bezel (see "Removing the two-piece bezel" on page 34).
4. Pull the loops of the drive assembly that is to be removed toward each other;
5. If you are instructed to return the drive assembly, follow all packaging
Simple-swap hard disk drives are not hot-swappable. Disconnect all
on page 29.
and external cables.
then, pull the assembly out of the bay.
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 5. Installing and replacing optional devices
53