Completing The Installation; Reinstalling The Two-Piece Bezel - Lenovo ThinkServer TS200 Installation And User Manual

4. Thread the cable through the rope clip and around an object that is not part of
If you have other devices to install or remove, do so now; otherwise, go to

"Completing the installation."

Completing the installation
To complete the installation, you must reinstall the two-piece bezel, reinstall the side
cover, connect all the cables and, for some devices, run the Setup utility. Follow the
instructions in this section.

Reinstalling the two-piece bezel

To reinstall the two-piece bezel, complete the following steps:
1. Install the upper bezel on the front of the server chassis:
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, make sure that it does not interfere with other
cables that are connected to the server.
a. Insert the two right-side tabs on the upper bezel into the matching holes on
the right side of the chassis.
b. Rotate the upper bezel to the left side of the chassis and press the bezel
clips into the matching indentations on the left side of the chassis until the
bezel clips snap into place 1 .
Chapter 5. Installing and replacing optional devices
67