Installing A Pci Card - Lenovo ThinkServer TS200 Installation And User Manual

5. Carefully grasp the end of the adapter and pull it out of the connector.
6. If you are instructed to return the adapter, follow all packaging instructions, and

Installing a PCI card

A PCI card can be installed in either PCI slot 1 or 2 on the system board. The PCI
card is supported on hot-swap server models only. The PCI card enables integrated
RAID levels 0, 1, 5, 6, and 10 support capability on hot-swap hard disk drives. For
configuration information, see the documentation that comes with the adapter.
Important: To ensure that your PCI card functions properly on UEFI-based servers,
make sure that the adapter firmware level is updated and the supporting drivers are
installed.
Attention:
updates. If the device is part of a cluster solution, verify that the latest level of code
is supported for the cluster solution before you update the code.
To install the PCI card, complete the following steps:
60
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide
Attention: To avoid breaking the retaining clips or damaging the adapter
connector, open and close the clips gently.
use any packaging materials for shipping that are supplied to you.
Some cluster solutions require specific code levels or coordinated code
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 29.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
Attention: To avoid breaking the retaining clips or damaging the PCI card
connector, open and close the clips gently.
3. Unlock and remove the side cover (see "Removing the side cover" on page
32).
4. Remove the hard disk drive fan assembly:
a. Rotate the hard disk drive fan assembly cable out of the system board.
b. Remove all hard disk drives.
c. Press and hold the drive cage release tab on the side of the drive cage;
then, rotate the drive cage out of the chassis until the retaining tab on top
of the cage locks into place.
d. Pull out on the hard disk drive fan assembly release tabs (at the blue dots);
then, rotate the hard disk drive fan assembly away from the drive cage
slightly.
5. Disconnect the signal and power cables and the existing SAS/SATA controller
(if one is installed); then, remove the controller from the server.
6. Touch the static-protective package that contains the PCI card to any
unpainted metal surface on the server. Then, remove the PCI card from the
package.
7. Align the PCI card so that the keys align correctly with the connector on the
system board.
Attention: Incomplete insertion might cause damage to the system board or
the PCI card.
Note: The drive cage should be in the open position. This illustration shows it
in the closed position.
8. Press the PCI card firmly into the connector on the system board.