Thermal Transfer Printing; Constant If Necessary; Ribbon Constant; Resin - Intermec EasyCoder PD41 User Manual

Direct Thermal Recommmended Settings
Paper Label
sensitivity Constant
Low
Standard
High
Ultra High
Use the above settings as initial settings and adjust the Label
Constant if necessary.

Thermal Transfer printing

• Ribbon Constant (range 50 to 115). Default 90.
• Ribbon Factor (range 10 to 50). Default 25.
• Label Offset (range -50 to 50). Default 0.
The following tables gives initial recommendations for suitable
settings.
Thermal Transfer Recommended Settings
Ribbon
Ribbon Constant
Wax
Hybrid
(Wax/Resin)
Resin
The receiving material has been excluded from this table, since
the ribbon has the largest impact for heat settings for thermal
transfer settings.
Use the above settings as initial values, and adjust the Ribbon

Constant if necessary.

EasyCoder PD41 Printer User's Guide
Appendix C - Setup Parameters (Fingerprint)
Label
Factor
100 40
90 40
80 40
70 40
Ribbon
Factor
80 20
90 25
100 30
Max Print
Speed (203 Speed (300
dpi
75
100
125
150
Max Print
Speed (203 Speed (300
dpi
75
100-150
150
Max Print
dpi)
50
75
100
100
Max Print
dpi)
75
75-100
100
77