Media Setup - Intermec EasyCoder PD41 User Manual

characters. The printer responds to each status inquiry or message
block with the printer status. The host should check the printer
status before downloading a message block to the printer. ENQ
causes the printer to transmit its highest priority status, while VT
instructs the printer to transmit all status that applies in the order
of their priority. The possible printer status in descending
priorities are
Condition
Buffer already full
Printhead raised
Ribbon fault
No label stock
Buffer now full
Printhead hot
Label at strip pin
Label skipping
Ready
Printing

Media Setup

The media parameters tell the firmware the characteristics of the
media that will be used, so the printout will be positioned
correctly with optimal quality.
Media Type
The Media Type parameters control how the label stop sensor
(LSS) and the media feed work. There are three media type
options:
• Gap is used for adhesive labels mounted on liner (backing
paper) or continuous paper stock with detection slots.
Default.
• Mark is used for labels, tickets, or strip provided with black
marks at the back.
• Continuous is used for continuous stock without any
detection slots or black marks.
EasyCoder PD41 Printer User's Guide
Appendix D — Setup Parameters (IPL)
Character
GS
US
US
EM
DC3
SI
FS
DC1
DC1
DC1
83