Intermec EasyCoder PD41 User Manual page 56

Chapter 5 — Setting up the Printer
Testmode: Activating
Data/
Step Ready Error RtW Button Comment
1
2 1 1
Testmode: Selecting Media Type
Data/
Step Ready Error
3 Release the button when LED corresponding to your media
type flashes
3a 1
3b 1
3c
4 The printer will automatically perform a sensor calibration
(Testfeed) according to your selection, and will select thermal
transfer printing if ribbons is installed, otherwise direct thermal.
Testmode: Printing Test Labels
Data/
Step Ready Error
5 The printer will then print four test labels after the testfeed in
step 4. To skip any test labels tap the button.
46
1 Make sure the printhead
lever is lowered. Press and
hold the Print button and
switch the printer On.
Testmode is activated after
10 seconds.
1 LEDs flash fast one at a time.
Keep button pressed.
RtW Button Comment
0
0
1 0
RtW Button Comment
EasyCoder PD41 Printer User's Guide
Labels with gaps.
Ticket with mark.
Variable length strip.