Running Testmode; Testmode - Intermec EasyCoder PD41 User Manual

Chapter 5 — Setting up the Printer
Hyperterminal settings (IPL only)
For more information on how to change setup parameters, see
the Fingerprint v10.X.X Programmer's Reference Manual, or the
IPL Programmer's Reference Manual.

Running Testmode

You can check certain settings, print a test label, or enter the
dump mode for troubleshooting purposes by using the printer
testmodes. Two testmodes are available, Testmode and Extended

Testmode.

Testmode
Normal testmode is used to select the media type, to print test
labels, and to enter dump mode. Testmode is entered by pressing
the Print button while switching the printer's power on. This
starts the Testmode which will go through a sequence of actions;
these can be controlled by pressing the Print button at the cue of
different LED flash patterns. The sequence of steps in testmode is
shown in the tables below:
EasyCoder PD41 Printer User's Guide 45