Smart Card Configuration Commands; Operational Scenarios; General - Intermec 6804DM Technical Reference Manual

Operation
Smart Card Configuration
Commands
The smart card reader can be enabled and disabled. The
reader can support smart Asynchronous (T=0 and T=1/fu-
ture) and Synchronous (future) smart cards, microprocessor
based cards as well as memory cards (future). But it must
be configured for the type of card that is to be used. Param-
eters to be set should be set in a single command, with op-
tions separated by semicolons:
Command: {CSR:data}Configures the smart card reader –
requires data
CSR data: T:MEM or ASYNC or SYNC for memory or async
or sync µP based card types
P:T0 or T1 for ASYNC card protocol to be used (T1 is fu-
ture)
M:I2C or SPI for I
ture)
E:ON or OFF to enable or disable the smart card reader
C:BIN or HEX to send commands to the card in binary or
ASCII Hex
R:BIN or HEX to receive status&data responses from card
in binary or ASCII Hex
A:ON or OFF to enable the auto print stand--alone demo
EXAMPLE: To turn the auto print demo ON:
"
"

Operational Scenarios

General

The magnetic card and button data are read automatically
by the 6804TCR and 6808 printers, and buffered internally
4-44 Intermec Portable Printers Technical Reference Manual
2
C or SPI type memory card interface (fu-
1 – put the printer into Easy Print by sending three
characters: ESC+EZ
2 – configure the printer by sending {CSR:A:ON}
SECTION 4