Pick Up Signal Function; Saving The Sweep Data - Icom IC-PCR1500 Instruction Manual

10
BAND SCOPE (Multi-function receiver/Component screens only)

Pick up signal function

The pick up signal function provides quick frequency setting
during the band scope operation. By clicking the desired
waveform, the clicked point frequency is set to the receive fre-
quency.
While pausing the band scope, you can also select the dis-
played signal frequency by clicking the waveform.
In this case, the selected frequency does not move, and the
previously received frequency is kept to center. So you can
select the previously received frequency simply by clicking a
center.
• [Receiver] screen
Click
• [Compo] screen
100
Click
Saving the sweeping data
The band scope sweep data can be saved in CSV (Comma
Separated Values) file format.
qClick the sweep start button (z≈x) to begin a sweep. (p. 98)
• Frequency mode is selected when zFREQx is clicked, and Time
mode is selected when zTIMEx is clicked.
wClick the recording start button (z x) to start saving the re-
ceiving signal contents while sweeping.
• When Time mode is selected in step q, the save time interval
can be selected— right click the zTIMEx button to indicate the
[Scope (TIME)] setting screen, then select the desired save time
interval. (e.g. when "1.0 Sec" is selected, time scope data is
saved every 1 sec.)
• You can save the sweeping contents with the desired file name in
the [File Name] box.
• The following data are saved.
- Recording start day and time
- Center frequency
- Sweeping frequency
- Sweeping time
- Electrolytic strength
eClick the recording stop button (z'x) to stop recording.