Wide Band Scope Function; Band Scope Options - Icom IC-PCR1500 Instruction Manual

Wide band scope function

The wide band scope function is available to sweep a wide
band scope (±1, 2 or 5 MHz.)
While sweeping the band scope, AF monitor function is also
available.
qRight-click the zFREQx button to call up the [Scope
(FREQ)] setting screen if it is not displayed.
wCheck the [Enable] check box in [Wide Band Scope] to en-
able the wide band scope function.
• Check the [AF Monitor] check box to monitor the receiving fre-
quency.
eClick the close ([X]) button to close the setting screen.
• [Scope (FREQ)] screen
q Check the check box to turn
[Wide Band Scope] ON.
w Check the check box to
turn [AF Monitor] ON.
BAND SCOPE (Multi-function receiver/Component screens only)
The following optional functions are available for the band
scope function. These settings can be defined using the
[Scope (FREQ)] screen.
qRight-click the zFREQx button to call up the [Scope
e Click
wCheck the desired check boxes in [Option], then click the

Band scope options

WFM Monitor function
The band scope function is normally used in AM and FM
modes only. This function allows it to be used as waveform
monitor in WFM mode.
1/2 sweep step function
This function sets the sweep step in half of the tuning step,
doubling the sweep resolution.
(FREQ)] setting screen if it is not displayed.
close ([X]) button to close the setting screen.
• [Scope (FREQ)] screen
q Check the check boxes.
10
10
w Click
103