Default Snmp Configuration; Snmp Configuration Guidelines - Cisco WS-C3560-48PS-S Software Configuration Manual

Chapter 26 Configuring SNMP

Default SNMP Configuration

Table 26-4
Table 26-4 Default SNMP Configuration
Feature
SNMP agent
SNMP community strings
SNMP trap receiver
SNMP traps
SNMP version
SNMPv3 authentication
SNMP notification type

SNMP Configuration Guidelines

An SNMP group is a table that maps SNMP users to SNMP views. An SNMP user is a member of an
SNMP group. An SNMP host is the recipient of an SNMP trap operation. An SNMP engine ID is a name
for the local or remote SNMP engine.
When configuring SNMP, follow these guidelines:
•
•
•
•
•
78-16156-01
shows the default SNMP configuration.
When configuring an SNMP group, do not specify a notify view. The snmp-server host global
configuration command autogenerates a notify view for the user and then adds it to the group
associated with that user. Modifying the group's notify view affects all users associated with that
group. Refer to the Cisco IOS Configuration Fundamentals Command Reference for Release 12.1
for information about when you should configure notify views.
To configure a remote user, specify the IP address or port number for the remote SNMP agent of the
device where the user resides.
Before you configure remote users for a particular agent, configure the SNMP engine ID, using the
snmp-server engineID global configuration with the remote option. The remote agent's SNMP
engine ID and user password are used to compute the authentication and privacy digests. If you do
not configure the remote engine ID first, the configuration command fails.
When configuring SNMP informs, you need to configure the SNMP engine ID for the remote agent
in the SNMP database before you can send proxy requests or informs to it.
Changing the value of the SNMP engine ID has important side effects. A user's password (entered
on the command line) is converted to an MD5 or SHA security digest based on the password and the
local engine ID. The command-line password is then destroyed, as required by RFC 2274. Because
of this deletion, if the value of the engine ID changes, the security digests of SNMPv3 users become
invalid, and you need to reconfigure SNMP users by using the snmp-server user username global
configuration command. Similar restrictions require the reconfiguration of community strings when
the engine ID changes.
Default Setting
Enabled
Read-Only: Public
Read-Write: Private
Read-Write-all: Secret
None configured
None enabled
If no version keyword is present, the default is version 1.
If no keyword is entered, the default is the noauth (noAuthNoPriv)
security level.
If no type is specified, all notifications are sent.
Catalyst 3560 Switch Software Configuration Guide
Configuring SNMP
26-7