Cisco WS-C3560-48PS-S Software Configuration Manual page 478

Configuring SNMP
Table 26-5 Switch Notification Types
Notification Type
Keyword
bgp
bridge
cluster
config
config-copy
entity
envmon
flash
hsrp
mac-notification
port-security
rtr
snmp
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
vtp
Though visible in the command-line help string, the fru-ctrl and flash insertion and removal keywords
Note
are not supported.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
Catalyst 3560 Switch Software Configuration Guide
26-12
Description
Generates BGP state change traps. This option is only available when the
enhanced multilayer image is installed.
Generates STP bridge MIB traps.
Generates a trap when the cluster configuration changes.
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these
environmental traps: fan, shutdown, supply, temperature.
Generates SNMP FLASH notifications.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for MAC address notifications.
Generates SNMP port security traps. You can also set a maximum trap rate
per second. The range is from 0 to 1000; the default is 0, which means that
there is no rate limit.
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications for authentication, cold start,
warm start, link up or link down.
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Generates a trap for TCP connections.
Generates a trap for SNMP VLAN membership changes.
Generates SNMP VLAN created traps.
Generates SNMP VLAN deleted traps.
Generates a trap for VLAN Trunking Protocol (VTP) changes.
Table 26-5.
Chapter 26 Configuring SNMP
78-16156-01