Default Vtp Configuration - Cisco WS-C3560-48PS-S Software Configuration Manual

Configuring VTP
VTP pruning is not designed to function in VTP transparent mode. If one or more switches in the
network are in VTP transparent mode, you should do one of these:
•
•
To configure VTP pruning on an interface, use the switchport trunk pruning vlan interface
configuration command (see the
pruning operates when an interface is trunking. You can set VLAN pruning-eligibility, whether or not
VTP pruning is enabled for the VTP domain, whether or not any given VLAN exists, and whether or not
the interface is currently trunking.
Configuring VTP
This section includes guidelines and procedures for configuring VTP. These sections are included:
•
•
•
•
•
•
•
•
•

Default VTP Configuration

Table 13-2
Table 13-2 Default VTP Configuration
Feature
VTP domain name
VTP mode
VTP version
VTP password
VTP pruning
Catalyst 3560 Switch Software Configuration Guide
13-6
Turn off VTP pruning in the entire network.
Turn off VTP pruning by making all VLANs on the trunk of the switch upstream to the VTP
transparent switch pruning ineligible.
Default VTP Configuration, page 13-6
VTP Configuration Options, page 13-7
VTP Configuration Guidelines, page 13-8
Configuring a VTP Server, page 13-9
Configuring a VTP Client, page 13-11
Disabling VTP (VTP Transparent Mode), page 13-12
Enabling VTP Version 2, page 13-13
Enabling VTP Pruning, page 13-13
Adding a VTP Client Switch to a VTP Domain, page 13-14
shows the default VTP configuration.
"Changing the Pruning-Eligible List" section on page
Default Setting
Null.
Server.
Version 1 (version 2 is disabled).
None.
Disabled.
Chapter 13 Configuring VTP
12-22). VTP
78-16156-01