Default Mstp Configuration; Mstp Configuration Guidelines - Cisco WS-C3560-48PS-S Software Configuration Manual

Software configuration guide
Hide thumbs Also See for WS-C3560-48PS-S:
Table of Contents

Advertisement

Configuring MSTP Features

Default MSTP Configuration

Table 16-3
Table 16-3 Default MSTP Configuration
Feature
Spanning-tree mode
Switch priority (configurable on a per-CIST port basis)
Spanning-tree port priority (configurable on a per-CIST port basis)
Spanning-tree port cost (configurable on a per-CIST port basis)
Hello time
Forward-delay time
Maximum-aging time
Maximum hop count
For information about the supported number of spanning-tree instances, see the
Spanning-Tree Instances" section on page

MSTP Configuration Guidelines

These are the configuration guidelines for MSTP:
Catalyst 3560 Switch Software Configuration Guide
16-12
shows the default MSTP configuration.
When you enable MST by using the spanning-tree mode mst global configuration command, RSTP
is automatically enabled.
For two or more switches to be in the same MST region, they must have the same VLAN-to-instance
map, the same configuration revision number, and the same name.
The switch supports up to 16 MST instances. The number of VLANs that can be mapped to a
particular MST instance is unlimited.
The UplinkFast and BackboneFast features are not supported with the MSTP.
PVST+, rapid PVST+, and MSTP are supported, but only one version can be active at any time. (For
example, all VLANs run PVST+, all VLANs run rapid PVST+, or all VLANs run MSTP.) For more
information, see the
"Spanning-Tree Interoperability and Backward Compatibility" section on
page
15-10. For information on the recommended trunk port configuration, see the
Other Features" section on page
VTP propagation of the MST configuration is not supported. However, you can manually configure
the MST configuration (region name, revision number, and VLAN-to-instance mapping) on each
switch within the MST region by using the command-line interface (CLI) or through the SNMP
support.
For load balancing across redundant paths in the network to work, all VLAN-to-instance mapping
assignments must match; otherwise, all traffic flows on a single link.
Default Setting
PVST+ (Rapid PVST+ and MSTP are disabled).
32768.
128.
1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
2 seconds.
15 seconds.
20 seconds.
20 hops.
15-9.
12-20.
Chapter 16
Configuring MSTP
"Supported
"Interaction with
78-16156-01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents