Understanding Multicast Vlan Registration - Cisco WS-C3560-48PS-S Software Configuration Manual

Chapter 19 Configuring IGMP Snooping and MVR

Understanding Multicast VLAN Registration

Multicast VLAN Registration (MVR) is designed for applications using wide-scale deployment of
multicast traffic across an Ethernet ring-based service provider network (for example, the broadcast of
multiple television channels over a service-provider network). MVR allows a subscriber on a port to
subscribe and unsubscribe to a multicast stream on the network-wide multicast VLAN. It allows the
single multicast VLAN to be shared in the network while subscribers remain in separate VLANs. MVR
provides the ability to continuously send multicast streams in the multicast VLAN, but to isolate the
streams from the subscriber VLANs for bandwidth and security reasons.
MVR assumes that subscriber ports subscribe and unsubscribe (join and leave) these multicast streams
by sending out IGMP join and leave messages. These messages can originate from an IGMP
version-2-compatible host with an Ethernet connection. Although MVR operates on the underlying
mechanism of IGMP snooping, the two features operate independently of each other. One can be enabled
or disabled without affecting the behavior of the other feature. However, if IGMP snooping and MVR
are both enabled, MVR reacts only to join and leave messages from multicast groups configured under
MVR. Join and leave messages from all other multicast groups are managed by IGMP snooping.
The switch CPU identifies the MVR IP multicast streams and their associated IP multicast group in the
switch forwarding table, intercepts the IGMP messages, and modifies the forwarding table to include or
remove the subscriber as a receiver of the multicast stream, even though the receivers might be in a
different VLAN from the source. This forwarding behavior selectively allows traffic to cross between
different VLANs.
You can set the switch for compatible or dynamic mode of MVR operation.
•
•
Only Layer 2 ports take part in MVR. You must configure ports as MVR receiver ports. Only one MVR
multicast VLAN per switch is supported.
78-16156-01
In compatible mode, multicast data received by MVR hosts is forwarded to all MVR data ports,
regardless of MVR host membership on those ports. The multicast data is forwarded only to those
receiver ports which MVR hosts have explicitly joined, either by IGMP reports or by MVR static
configuration. Also, IGMP reports received from MVR hosts are never forwarded out of MVR data
ports that were configured in the switch.
In dynamic mode, multicast data received by MVR hosts on the switch is forwarded from only those
MVR data and client ports that the MVR hosts have explicitly joined, either by IGMP reports or by
MVR static configuration. Any IGMP reports received from MVR hosts are also forwarded from all
the MVR data ports in the switch. This eliminates using unnecessary bandwidth on MVR data port
links, which occurs when the switch runs in compatible mode.
Understanding Multicast VLAN Registration
Catalyst 3560 Switch Software Configuration Guide
19-13