Automatic Recovery Of Cluster Configuration - Cisco WS-C3560-48PS-S Software Configuration Manual

Planning a Switch Cluster
Figure 5-7
Management

Automatic Recovery of Cluster Configuration

The active cluster command switch continually forwards cluster-configuration information (but not
device-configuration information) to the standby cluster command switch. This ensures that the standby
cluster command switch can take over the cluster immediately after the active cluster command switch
fails.
Automatic discovery has these limitations:
•
•
•
Catalyst 3560 Switch Software Configuration Guide
5-12
Catalyst 1900, Catalyst 2820, Catalyst 2900 XL, Catalyst 2950, and Catalyst 3500 XL cluster
member switches must be connected to the cluster standby group through their management
VLANs. For more information about VLANs in switch clusters, see these sections:
"Discovery Through Different VLANs" section on page 5-7
–
– "Discovery Through Different Management VLANs" section on page 5-7
VLAN Connectivity between Standby-Group Members and Cluster Members
Command
switch
VLANs 9,16
VLAN 9
VLAN 9
VLAN 9
This limitation applies only to clusters that have Catalyst 2950, Catalyst 3550, Catalyst 3560, and
Catalyst 3750 command and standby cluster command switches: If the active cluster command
switch and standby cluster command switch become disabled at the same time, the passive cluster
command switch with the highest priority becomes the active cluster command switch. However,
because it was a passive standby cluster command switch, the previous cluster command switch did
not forward cluster-configuration information to it. The active cluster command switch only
forwards cluster-configuration information to the standby cluster command switch. You must
therefore rebuild the cluster.
This limitation applies to all clusters: If the active cluster command switch fails and there are more
than two switches in the cluster standby group, the new cluster command switch does not discover
any Catalyst 1900, Catalyst 2820, and Catalyst 2916M XL cluster member switches. You must
re-add these cluster member switches to the cluster.
This limitation applies to all clusters: If the active cluster command switch fails and becomes active
again, it does not discover any Catalyst 1900, Catalyst 2820, and Catalyst 2916M XL cluster
member switches. You must again add these cluster member switches to the cluster.
Passive
command switch
VLANs 9,16
Management
VLAN 16
Member switches
Chapter 5 Clustering Switches
Standby
command switch
Management
VLAN 16
VLAN 16
78-16156-01