Cisco WS-C3560-48PS-S Software Configuration Manual page 43

Chapter 1 Overview
•
•
Note For additional descriptions of the management interfaces, see the
section on page
Availability Features
•
•
•
•
•
•
•
VLAN Features
•
•
•
78-16156-01
In-band management access through SNMP versions 1 and 2c, and 3 get and set requests
Out-of-band management access through the switch console port to a directly attached terminal or
to a remote terminal through a serial connection or a modem
1-11.
HSRP for command switch and Layer 3 router redundancy
UniDirectional Link Detection (UDLD) and aggressive UDLD for detecting and disabling
unidirectional links on fiber-optic interfaces caused by incorrect fiber-optic wiring or port faults
IEEE 802.1D Spanning Tree Protocol (STP) for redundant backbone connections and loop-free
networks. STP has these features:
– Up to 128 spanning-tree instances supported
– Per-VLAN spanning-tree plus (PVST+) for balancing load across VLANs
Rapid PVST+ for balancing load across VLANs and providing rapid convergence of
–
spanning-tree instances
– UplinkFast and BackboneFast for fast convergence after a spanning-tree topology change and
for achieving load balancing between redundant uplinks, including Gigabit uplinks
IEEE 802.1S Multiple Spanning Tree Protocol (MSTP) for grouping VLANs into a spanning-tree
instance and for providing multiple forwarding paths for data traffic and load balancing and
IEEE 802.1W Rapid Spanning Tree Protocol (RSTP) for rapid convergence of the spanning tree by
immediately transitioning root and designated ports to the forwarding state
Optional spanning-tree features available in PVST+, rapid-PVST+, and MSTP mode:
– Port Fast for eliminating the forwarding delay by enabling a port to immediately transition from
the blocking state to the forwarding state
– BPDU guard for shutting down Port Fast-enabled ports that receive bridge protocol data units
(BPDUs)
– BPDU filtering for preventing a Port Fast-enabled port from sending or receiving BPDUs
– Root guard for preventing switches outside the network core from becoming the spanning-tree
root
– Loop guard for preventing alternate or root ports from becoming designated ports because of a
failure that leads to a unidirectional link
Equal-cost routing for link-level and switch-level redundancy
RPS support through the Cisco RPS 300 and Cisco RPS 675 for enhancing power reliability
Support for up to 1005 VLANs for assigning users to VLANs associated with appropriate network
resources, traffic patterns, and bandwidth
Support for VLAN IDs in the full 1 to 4094 range allowed by the IEEE 802.1Q standard
VLAN Query Protocol (VQP) for dynamic VLAN membership
"Network Configuration Examples"
Catalyst 3560 Switch Software Configuration Guide
Features
1-5