Configuring Basic Eigrp; Enabling The Eigrp Feature - Cisco Nexus 3000 Series Configuration Manual

Chapter 4 Configuring EIGRP
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
Table 4-1
Parameters
NSF signal time
Redistribution
Split horizon

Configuring Basic EIGRP

This section includes the following topics:
•
•
•
•
•

Enabling the EIGRP Feature

You must enable the EIGRP feature before you can configure EIGRP.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
feature eigrp
Example:
switch(config)# feature eigrp
Default EIGRP Parameters (continued)
Enabling the EIGRP Feature, page 4-9
Creating an EIGRP Instance, page 4-10
Restarting an EIGRP Instance, page 4-12
Shutting Down an EIGRP Instance, page 4-13
Shutting Down EIGRP on an Interface, page 4-13
configure terminal
feature eigrp
(Optional) show feature
(Optional) copy running-config startup-config
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Default
20
Disabled
Enabled
Purpose
Enters configuration mode.
Enables the EIGRP feature.
Configuring Basic EIGRP
4-9