Cisco WS-C3560-48PS-S Software Configuration Manual page 48

Default Settings After Initial Switch Configuration
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature
Port parameters
Operating mode
Interface speed and duplex mode
Auto-MDIX
Flow control
Power over Ethernet (PoE)
SmartPort macros
VLANs
Default VLAN
VLAN trunking
Trunk encapsulation
VTP mode
VTP version
Voice VLAN
STP
MSTP
Optional spanning-tree features
DHCP snooping
DHCP snooping
DHCP snooping information option
IGMP snooping
IGMP snooping
IGMP filters
IGMP throttling
MVR
Port-based Traffic
Broadcast, multicast, and unicast storm
control
Protected ports
Unicast and multicast traffic flooding
Secure ports
CDP
UDLD
SPAN and RSPAN
Catalyst 3560 Switch Software Configuration Guide
1-10
Default Setting
Layer 2 (switchport)
Autonegotiate
Disabled
Off
Auto
None defined
VLAN 1
Dynamic auto (DTP)
Negotiate
Server
1
Disabled
PVST+ enabled on VLAN 1
Disabled
Disabled
Disabled
Enabled
Enabled
None applied
Deny
Disabled
Disabled
None defined
Not blocked
None configured
Enabled
Disabled
Disabled
Chapter 1
More information in...
Chapter 10, "Configuring Interface
Characteristics"
Chapter 11, "Configuring SmartPort
Macros"
Chapter 12, "Configuring VLANs"
Chapter 13, "Configuring VTP"
Chapter 14, "Configuring Voice VLAN"
Chapter 15, "Configuring STP"
Chapter 16, "Configuring MSTP"
Chapter 17, "Configuring Optional
Spanning-Tree Features"
Chapter 18, "Configuring DHCP
Features"
Chapter 19, "Configuring IGMP Snooping
and MVR"
Chapter 20, "Configuring Port-Based
Traffic Control"
Chapter 21, "Configuring CDP"
Chapter 22, "Configuring UDLD"
Chapter 23, "Configuring SPAN and
RSPAN"
Overview
78-16156-01