Table of Contents
Advertisement
9. Click on "OK" when finished.
10. From the "File" menu, select "Properties".
Select the "Settings" tab, and you should see a screen like
the following.
Figure 20: Null Modem Settings
11. Ensure that the "Emulation" is set to "VT100".
12. There should be no need to use the "Terminal Setup"
button - the default settings should be fine.
13. Click "OK" to close the properties box.
14. You can now connect and power up the Error! Reference
source not found.. If nothing appears on the screen, press
ESC.
15. You can now configure the Error! Reference source not
found., as described in Terminal Mode Configuration on
page 21.
E - Terminal Programs
77
Advertisement
Table of Contents
