Table of Contents
Advertisement
10BaseT Cabling:
If your network uses 10BaseT cable, insert one end into
the Error! Reference source not found.'s RJ-45 jack and
the other end into the 10BaseT hub. Keep in mind that the
maximum effective length from the hub to the device is
100 meters.
Warning: Do not attempt to connect more than
one type of cable at the same time or
change the network cable while the
Error! Reference source not found. is
powered On.
3. Connect Modem & Phone Line
Connect the modem, using a standard serial cable, to the
Error! Reference source not found.'s serial port. Next,
connect a telephone line from an RJ-11 style phone jack to
the modem.
4. Connect Power Adapter
Connect the modem's power adapter to the modem and the
Error! Reference source not found.'s power adapter to
the Error! Reference source not found.. Power both de-
vices On.
5. Check the LEDs
When the Error! Reference source not found. is pow-
ered On, both LEDs should light, then the Error LED
should go off. If the Error LED stays on, there is a hard-
Only use the power adapter provided
with your unit. Using a different one
may cause hardware damage.
Installation
11
Advertisement
Table of Contents
