Table of Contents
Advertisement
Back Panel
The following diagram shows the back panel of the Error!
Reference source not found.. The Error! Reference source
not found. is identical except for having 2 serial ports rather
than 4.
Figure 4: Back Panel (Error! Reference source not found.)
1
Power port
2
10Base2 port
3
10BaseT LED
indicator.
4
10BaseT port
5
DIP switches
6
Serial Ports
Connect the power adapter here.
Connect 10Base2 cabling here.
This will light when the 10BaseT
connector is in use.
Connect 10BaseT cabling here.
Set Normal or Configuration
mode. See the following Dip
Switches Table for details.
Connect the modems to these
ports. The Error! Reference
source not found. has 2 ports; the
Error! Reference source not
found. has 4 ports.
Port 1, used for configuration, is
closest to the side of the device.
Introduction
7
Advertisement
Table of Contents
