Table of Contents
Advertisement
2
Installation
Requirements
Ethernet Network employing 10BaseT or 10Base2 cable
and the TCP/IP protocol.
An external modem or ISDN TA (Terminal Adapter).
Configuration serial cable for Terminal mode configura-
tion (supplied).
Single user account with a local ISP.
Procedure
The installation choices are as follows.
Configure, then Install
Configuration is done using a serial cable connection and a
VT100 terminal compatible program, before installation. The
only advantage of this method is that you can change the
default IP Address (192.168.0.1) before connection to your
LAN.
Install, then Configure
Here, you connect the Error! Reference source not found. to
your network and then configure it using your WEB Browser.
If the default IP Address (192.168.0.1) is already used by
another device, the other device must be turned OFF until the
9
Advertisement
Table of Contents
