Enrolling Loop Devices (Ifm2L) - INIM Electronics PREVIDIA ULTRA Manual

Configuration manual
Connection via RS485 BUS
The BUS connection needs the addressing of any repeater in configuration, in
order for the control panel to identify each module individually.
To assign an address to a repeater, it is necessary to enter the configuration procedure
starting from the display of the module itself, as described in the paragraph 2.3.
A window will open, select the desired address in the programming field, then
tap on Set. The available addresses are from 1 to 14.
Attention:
The "0" address is reserved to the main FPMCPU module. Do not use.
2.6

Enrolling loop devices (IFM2L)

The operations required for the configuration of the IFM2L network modules involve the configuration of the devices
connected to the loops.
The selection of the module from the internal layout section of the cabinet (paragraph 2.1 Access to programming, [A]) will
access the configuration section which, in addition to providing the change address button (at the top) also provides two identical
sections for each of the two loops (connected to the Loop-A and Loop-B terminals). The present document describes the
Configuring the fire detection system
Address
14
Esc Set
11