Endress+Hauser Proline Prosonic Flow W 400 Operating Instructions Manual page 103

Proline Prosonic Flow W 400 HART
Parameter
Assign process variable
On value low flow cutoff
Off value low flow cutoff
Endress+Hauser
Navigation
"Setup" menu → Low flow cut off
‣
Low flow cut off
Assign process variable (1837)
On value low flow cutoff (1805)
Off value low flow cutoff (1804)
Parameter overview with brief description
Prerequisite
–
A process variable is selected
in the Assign process variable
parameter (→  103).
A process variable is selected
in the Assign process variable
parameter (→  103).
Description
Select process variable for low
flow cut off.
Enter on value for low flow cut
off.
Enter off value for low flow cut
off.
Commissioning
→  103
→  103
→  103
Selection / User Factory setting
entry
• Off Flow velocity
• Volume flow
• Mass flow
• Flow velocity
Positive floating- 0.3 m/s
point number
0 to 100.0 % –
103