Unit Configuration; Compatibility (I) - Danfoss VLT Aqua Drive FC 202 Programming Manual

Programming Guide | VLT® Aqua Drive FC 202
Option Name
[0]* Off
[1] On
30-23 Locked Rotor Detection Time [s]
Default value: 0.10 s
Setup: All setups
Data type: Uint8
Time period for detecting the locked rotor condition. A low parameter value leads to faster detection.

30-5* Unit Configuration

5.28.2
30-50 Heat Sink Fan Mode
Default value: –
Setup: 2 setups
Data type: Uint8
Select how the heat sink fan responds to operating conditions. Use parameter 14-52 Fan Control to control the minimum fan speed.
Option Name
[0] Simple profile
[1] Reduced acoustics
[2] Standard
[3] Cooler operation
5.28.3

30-8* Compatibility (I)

30-81 Brake Resistor (ohm)
Default value: Size related
Setup:
All setups
Data type: Uint32
Set the brake resistor value in Ω. This value is used for monitoring the power to the brake resistor in parameter 2-13 Brake Power
Monitoring. This parameter is only active in drives with an integral dynamic brake.
30-85 Motor Frequency
Default value: Size related
© 2024.06
Description
Protects the motor from the locked rotor condition. The control
algorithm detects a possible locked rotor condition in the motor
and trips the drive to protect the motor.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Description
The simple profile is a passive fan control based on the current
temperature state of the drive. This option represents the classic
operating behavior of fans.
Parameter type:
Conversion index:
Change during operation:
Parameter type:
AU361182657213en-002101 / 130R0338 |
Parameter Descriptions
Range, 0.05 - 1 s
-2
True
Option
–
True
Range, 5 - 65535.00 Ohm
-2
True
Range, 20.0 - 1000.0 Hz
623