Danfoss VLT Aqua Drive FC 202 Programming Manual page 611

Programming Guide | VLT® Aqua Drive FC 202
29-22 Derag Power Factor
Default value: 200%
Setup: All setups
Data type: Uint16
Set a correction if derag detection reacts on a power value that is too low.
29-23 Derag Power Delay
Default value: 601 s
Setup:
All setups
Data type: Uint16
Set the time that the drive must remain on reference and a high-power condition for a derag to occur.
29-24 Low Speed [RPM]
Default value: Size related
Setup: All setups
Data type: Uint16
Set the output speed used for registration of derag power at low speed in RPM.
29-25 Low Speed [Hz]
Default value:
Size related
Setup: All setups
Data type:
Uint16
Set the output speed used for registration of derag power at low speed in Hz.
29-26 Low Speed Power [kW]
Default value: Size related
Setup: All setups
Data type:
Uint32
Set the derag power at low speed in kW.
29-27 Low Speed Power [HP]
Default value: Size related
Setup:
All setups
Data type: Uint32
Set the derag power at low speed in hp.
© 2024.06
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
Parameter type:
Conversion index:
Change during operation:
AU361182657213en-002101 / 130R0338 |
Parameter Descriptions
Range, 1 - 400%
0
True
Range, 1 - 601=Off s
0
True
Range, 0 - par. 29-28
67
True
Range, 0 - Par. 29-29
-1
True
Range, 0 - 5.50 [kW]
1
True
Range, 0 - 7.5 [hp]
-2
True
611