D Receiving A Test Call; D Receiving A Test Acknowledgment - Icom IC-M804 Instruction Manual

6
DSC OPERATION
■ Receiving DSC calls (other)

D Receiving a Test call

NOTE: When "Test ACK" is set to "Auto," the
transceiver automatically sends an Acknowledgment.
(p. 49)
In that case, both the TX and RX calls are saved in
the Transmitted and Received Call Logs. (p. 46)
When a Test call is received:
• The alarm sounds until you turn it OFF.
• "Received Test Call" is displayed.
1. Push
Alarm Off
2. Push the Software Key below the intended
operation.
: Ignores the call and returns to the
Ignore
Main screen.
: Puts the RX task on hold and returns
Hold
to the Main screen.
: Sends an Acknowledgment
Able
"Able to comply."
: Immediately enters the DSC Task
Accept
mode.
L Rotate [CH/GRP] to confi rm the call contents.
L See page 23 for details of the Software Key
functions in the DSC Task mode.
3. Push Standby Mode
return to the Main screen.
TIP: See page 37 for details of the Test
Acknowledgment procedures.
45
to turn OFF the alarm.
Rotate
, and then
OK

D Receiving a Test Acknowledgment

When a Test Acknowledgment is received:
• The alarm sounds until you turn it OFF.
• "Received Test ACK" is displayed.
1. Push Alarm Off
2. Push
Close Call RCVD Window
L Rotate [CH/GRP] to confi rm the call contents.
L See page 23 for details of the Software Key
functions in the DSC Task mode.
3. Push
Standby Mode
return to the Main screen.
to
to turn OFF the alarm.
.
Rotate
, and then
OK
to