Receiving Dsc Calls (Other); D Receiving An Individual Call - Icom IC-M804 Instruction Manual

6
DSC OPERATION

■ Receiving DSC calls (other)

D Receiving an Individual call

NOTE:
• To receive an Individual call, push [D-SCAN] to
enter the DSC watch mode. (p. 10)
• When "Individual ACK" is set to "Auto (Able)" or
"Auto (Unable)," the transceiver automatically
sends an Acknowledgment "Able to comply" or
"Unable to comply." (p. 49)
In that case, both the TX and RX calls are saved in
the Transmitted and Received Call Logs. (p. 46)
When an Individual call is received:
• The alarm sounds until you turn it OFF.
• "Received Individual Call" is displayed.
1. Push
Alarm Off
2. Push the Software Key below the intended
operation.
: Ignores the call and returns to the
Ignore
Main screen.
: Puts the RX task on hold and returns
Hold
to the Main screen.
: Sends an Acknowledgment "Able to
Able
comply" without any changes.
: Enters the DSC Task mode
Accept
immediately.
NOTE: When
Accept
an Acknowledgment can be send in the DSC Task
mode. To send the Acknowledgment, go to step 3.
To return to the Main screen without sending the
Acknowledgment, go to step 7.
41
to turn OFF the alarm.
is selected in this step,
3. Push a key to select an Acknowledgment option.
• The Call Contents screen is displayed.
4. Confirm the contents.
5. Push to send an Individual
Call
Acknowledgment.
6. Hold down [PTT] to talk.
7. Push
Standby Mode
return to the Main screen.
TIP: When sending the Acknowledgment, select one
of three options, depending on your situation.
See pages 30 and 31 for details of the
Individual Acknowledgment procedures.
Rotate
, and then to
OK