Preparation; Entering The Mmsi Code - Icom IC-M804 Instruction Manual

■ Entering the MMSI code

The Maritime Mobile Service Identity (MMSI: DSC self
ID) code consists of 9 digits. You can only enter the
code when turning ON the transceiver for the fi rst time.
This initial code can be entered only once.
After entering, it can be changed only by your dealer
or distributor.
If your MMSI code has already been entered, doing
the steps below is not necessary.
1. Hold down [ ] to turn ON the transceiver.
• Three short beeps sound, and then "Push [ENT] to
Register your MMSI" is displayed.
2. Push [ENT] to start entering the MMSI code.
• The "MMSI" screen is displayed.
L To skip the entry, push [CLR] twice.
If you skip the entry, you cannot make a DSC call. To
enter the code after skipping, turn OFF the power, and
then turn it ON again.
3. Enter the MMSI code.
4. Repeat step 3 to enter all 9 digits.
5. Push the Software key
entered code.
• The "MMSI CONFIRMATION" screen is displayed.
Rotate
+
Push
to set the
Finish

PREPARATION

6. Enter your MMSI code again to confirm.
7. Push to set the confirmation code.
Finish
• When your MMSI code is successfully entered, "MMSI
Successfully Registered" is briefl y displayed, and then
the Main screen opens.
L Your MMSI code is also displayed on the opening screen.
3
2
3
Rotate
+
Push
8