Digital Control F2 DCI DigiGuide User Manual page 59

STEP 9 OF 10
Toggle to the lowest band, click to select, toggle to the Down band, and then
click to select it.
STEP 10 OF 10
Select Pair and proceed as
you normally would when
pairing both bands at one
location.
GLOSSARY DEFINITIONS
*INTERFERENCE
Your locator can only detect active interference, not passive interference, such as rebar.
Lower frequency bands tend to perform better around passive interference. Middle
bands can perform better in deeper bores and may have longer Target Steering
capability. High bands have slightly less signal strength, but tend to offer better
performance around active interference such as power lines.
*BAND WITH THE LEAST NOISE
Interference varies with time and location, and no band works perfectly in all conditions.
Different bands are better for different kinds of interference. Lower frequency bands
tend to perform better in passive interference. Middle bands can perform better in
deeper bores and may have longer Target Steering capability. Higher frequency bands
have slightly less signal strength but tend to offer better performance around active
interference such as power lines.
DIGITAL CONTROL, INC
DIGITRAK FALCON F2 TOP TOGGLE USER MANUAL
DCI DigiGuide 05.18.2024
59