Digital Control F2 DCI DigiGuide User Manual page 24

If you are using a V2 transmitter with MultiPower Mode, see the
"V2 Transmitter Quick Start Guide" for instructions how to set
the power mode.
STEP 4 OF 4
Select Pair,
then Transmitter pairing
request.
The locator beeps and displays a check mark after a successful pairing.
CALIBRATE INTRO
Calibration is required anytime you change your transmitter, locator, drill
head, or perform a new frequency scan and then pair.
Calibrate both bands with the transmitter in the housing flat on the ground in
a low-noise, metal-free environment immediately after pairing.
To calibrate any other time, from the Main menu select Calibration, then 1PT
CAL before continuing with the following steps.
CALIBRATE, UP
STEP 1 OF 6
From the Main menu, select
Calibration.
Select 1 pt calibration.
DIGITAL CONTROL, INC
DIGITRAK FALCON F2 TOP TOGGLE
✓
USER MANUAL
DCI DigiGuide 05.18.2024
24