Digital Control F2 DCI DigiGuide User Manual page 3

Ensure that all underground utilities have been located, exposed, and/or
accurately marked prior to drilling. Follow all proper safety precautions,
such as potholing.
DCI equipment is not explosion-proof and should never be used near
flammable or explosive substances.
Wear jobsite protective/safety clothing such as dielectric boots, gloves,
hard hat, high-visibility vest, and safety glasses.
Maintain a minimum distance of 20 cm from the front of the locator to
the user's torso to ensure compliance with RF exposure requirements.
Comply with federal, state, and local governmental regulations (such as
OSHA) and all other customary or required safety precautions.
If you have any questions about the operation of your guidance system,
please contact DCI Customer Service for assistance.
SPECIAL NOTES ABOUT INTERFERENCE
While DCI guidance systems provide you with technology to combat active
interference (and passive interference, with the Sub-k Rebar transmitter), no
guidance system is immune to all interference.
Interference can lead to inaccurate depth readings and/or interruption or
loss of data. Never rely on data that does not display quickly and/or remain
stable.
The Falcon frequency optimizer selects frequencies based on measured
interference at a specific time and location.
Interference levels change with time and with even minor changes in location.
The frequency optimizer is not a substitute for prudent operator judgment. If
performance drops while drilling, consider switching to the other selected
band (not available on the Falcon F1) or use Max Mode.
DIGITAL CONTROL, INC
DIGITRAK FALCON F2 TOP TOGGLE USER MANUAL
DCI DigiGuide 05.18.2024
3