Table of Contents
Advertisement
Online displayed.
Online Connection
Information Window
Target PLC displayed in green.
Note: If an online connection is
made to the relay PLC, the relay
PLC will also be the target PLC
by default.
The
icon will be displayed next to
the Communication Unit/port that is
presently connected and accessible.
Note: If an online connection is made to the relay PLC, that PLC will be both the relay PLC and
the target PLC. The Communications Units mounted in the relay PLC will be displayed in
the Online Connection Information Window. Normally, the CX-Integrator is used with the
same PLC as both the relay PLC and the target PLC.
Once a connection has been made, it is possible to download the network configuration
and switch the target PLC to any PLC on the network. To do this, right-click a PLC on a
network and select Connect to this PLC.
Note
CX-Integrator Communications Connections
There are three levels of CX-Integrator communications connections depending on
where the connection is made.
Network Type
COM Port No., Baud Rate, Parity, Data
Bits, Stop Bits
Node Address
Network Address
Communications Unit model (CPU Unit model for CPU Unit built-in serial ports)
Communications Unit name (CPU Unit for CPU Unit built-in serial ports)
1-5
Relay PLC's CPU Unit model
Relay PLC's FINS destination network
address
Relay PLC's FINS destination node
address
Target PLC's CPU Unit model
Target PLC's network address
Target PLC's node address
Unit No.
Window Descriptions
1-5-2
Main Window
Relay PLC
communications
settings
Target PLC
information
Communications Unit and port information
for target PLC
Displayed from the top in the following order.
• CPU ports: CPU Unit serial ports
• Inner Boards (Nothing is displayed if no
Inner Boards are mounted.)
• Communications Units
1-37
Advertisement
Table of Contents
