Changing Node Addresses - Omron CX-INTEGRATOR - V2.3 REV 02-2009 Operation Manual

2-5 Creating Virtual Network Configurations Offline
2-5-3

Changing Node Addresses

To display the dialog box again, select Options from the Tools Menu, and select
Display the information message while inserting the Slave Device which cannot be used
on Mode 0, and click the OK Button.
2-5-3 Changing Node Addresses
Component − Change Node Address
Node address between 0 and 63 will be automatically assigned to devices as they are
added to the network.
Use the following procedure to change a node address that has been assigned.
1 Select the device for which the node address is to be changed.
2 Select Component
3 Change the node address to a value between 0 and 63 and click the OK Button. The
2-44
−
Change Node Address from the menu bar. Alternately,
right-click the device and select Change Node Address from the pop-up menu.
The Change Node Address Dialog Box will be displayed.
node address will be changed.
Repeat this operation to change any other node address in the network that should
be different.