Plc Setup Settings - Omron CJ - 09-2009 Operation Manual

PLC Setup
Cases when settings must be changed
You want to set the various parameters for the origin search func-
tion. (See note 4.)
You want to use the Serial PLC Link. (See note 4.)
Note
7-1-2

PLC Setup Settings

288
1. CJ1-H CPU Units only.
2. CJ1-H and CJ1M CPU Units only.
3. CJ1-H and CJ1 CPU Units only.
4. CJ1M CPU Units only.
5. Not supported when the CJ1W-PD022 Power Supply Unit is mounted. (Re-
fer to Power OFF Operation on page 451.)
All non-binary settings in the following tables are hexadecimal unless other-
wise specified.
The Programming Console addresses given in this section are used to access
and change settings in the PLC Setup when using a Programming Console or
the Programming Console function of an NS-series Programming Terminal.
The PLC Setup is stored in the Parameter Area, which can be accessed only
from a Programming Device. Do not use the Programming Console
addresses as operands in programming instructions. They will be interpreted
as addresses in the CIO Area of I/O memory.
Setting(s) to be changed
• Pulse outputs 0/1: Origin search, origin return ini-
tial speed
• Pulse outputs 0/1: Origin search high speed
• Pulse outputs 0/1: Origin search proximity speed
• Pulse outputs 0/1: Origin compensation value
• Pulse outputs 0/1: Origin search acceleration rate
• Pulse outputs 0/1: Origin search deceleration rate
• Pulse outputs 0/1: Limit input signal type
• Pulse outputs 0/1: Origin proximity input signal
type
• Pulse outputs 0/1: Origin input signal type
• Pulse outputs 0/1: Positioning monitor time
• Pulse outputs 0/1: Origin return target speed
• Pulse outputs 0/1: Origin return acceleration rate
• Pulse outputs 0/1: Origin return deceleration rate
• RS-232C Communications Port: Serial Communi-
cations Mode
• Serial PLC Link: Format
• Serial PLC Link: Number of words to send
• Serial PLC Link: Maximum unit number
• Serial PLC Link: Polled Unit unit number
Section 7-1