Omron CJ - 09-2009 Operation Manual page 365

PLC Setup
High-speed Counter 0 Reset Method
Programming Settings
Console
address
Word Bits
+50 04 to 07 0 hex: Z phase,
software reset
(stop comparing)
1 hex: Software
reset (stop com-
paring)
2 hex: Z phase,
software reset
(continue com-
paring)
3 hex: Software
reset (continue
comparing)
High-speed Counter 0 Counting Mode
Programming Settings
Console
address
Word Bits
+50 08 to 11 0 hex:
Linear mode
1 hex:
Ring mode
High-speed Counter 0 Circular Max. Count (Ring Counter Maximum Value)
Programming Settings
Console
address
Word Bits
+51 00 to 15 00000000 to
FFFFFFFF hex
(See note.)
+52 00 to 15
Default
0 hex Specifies the reset method for high-
speed counter 0.
Default
0 hex Specifies the counting mode for high-
speed counter 0.
Default
Sets the max. ring count for high-
00000000
hex
speed counter 0.
When the high-speed counter 0
counting mode is set to ring mode,
the count will be reset to 0 automati-
cally when the counter PV exceeds
the max. ring count.
Note When the CX-Programmer is being used to make the setting, the setting is
input in decimal.
Function
Area flags/
---
Function
Area flags/
---
Function
Area flags/
A270
(Rightmost 4
digits of the
high-speed
counter 0
PV)
A271
(Leftmost 4
digits of the
high-speed
counter 0
PV)
Section 7-1
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When power is
turned ON
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
317