Simple Teaching - Omron 2D CODE READER User Manual

Section 1
Studying the V400-F

Simple Teaching

Use "Simple Teaching" to check whether codes on the work piece are readable.
"Simple Teaching" enables you to set necessary reading conditions automatically by simple
operations.
To change reading conditions or set them in detail, use the setting mode.
Turning ON the power
Performing teaching
V400-F050/250/350
22
User's Manual
Turn ON the power to the monitor.
• When using F150-M05L-2D, make sure
that it is connected before turning ON the
power to the power supply device.
Turn ON the power to the power supply device.
The POWER LED (green) will light up.
Capture the work piece.
Switch to the real-time image display
mode, and adjust the position and
brightness of the work piece while
observing the image on the monitor.
[STILL]: Still image
[LIVE]: Real-time image
Display switching
Press the left button to switch
from the still image to the real-
time image or vice versa.
Brightness adjustment
Hold down the left button for more
than two seconds, to display the
exposure time adjustment screen.
The brightness will be adjusted
based on the exposure time.
Perform teaching.
Hold down the right button for
more than two seconds, to perform

"Simple Teaching".

When teaching is completed successfully, the
teaching and reading results will be displayed.
Three indicators will light: Power (green), OK
(blue), and NG (red). Select [OK] to save the
results.
Indicators light:
Power (green), OK (blue),
NG (red).
The POWER LED
(green) will light up.
Press
Hold down for
more than two
seconds.
Hold down for
more than two
seconds.