Cisco CE-511 Hardware Installation Manual page 52

Safety Warnings
Read the installation instructions before connecting the system to the power
Warning
source. Statement 1004
Before working on a system that has an on/off switch, turn OFF the power and
Warning
unplug the power cord. Statement 1
This unit might have more than one power supply connection. All connections
Warning
must be removed to de-energize the unit. Statement 1028
This unit is intended for installation in restricted access areas. A restricted
Warning
access area is where access can only be gained by service personnel through
the use of a special tool, lock and key, or other means of security, and is
controlled by the authority responsible for the location. Statement 37
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits
Warning
to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits,
and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45
connectors. Use caution when connecting cables. Statement 1021
Warning This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S.
(240 VAC, 10A international) is used on the phase conductors (all
current-carrying conductors). Statement 13
This equipment must be grounded. Never defeat the ground conductor or
Warning
operate the equipment in the absence of a suitably installed ground conductor.
Contact the appropriate electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available. Statement 1024
Cisco Content Engine 511 and 566 Hardware Installation Guide
2-2
Download from Www.Somanuals.com. All Manuals Search And Download.
Chapter 2 Preparing to Install the Content Engine
OL-5756-01