Table of Contents
Advertisement
Solution 6000-IP
Installation Manual
Inputs > Zone Properties >
Pulse Count Time
Value
000 - 255
Pulse count time operates in accordance with the pulse
count option set in MENU 3-1-3. There are four modes of
operation that can be set including:
♦
Pulse Count
♦
Inertia Pulse
♦
Door Open Too Long
♦
PreDelay
When programming the pulse count time, enter the value
between 000 to 255, then set the multiplier in seconds,
minutes or hours.
1) Press [MENU] + [3] + [1] + [4] and use the up and
down arrows to highlight the Zone in the list then
press [OK]. Alternatively, you can enter the zone
number directly and press [OK]. The keypad will
display the current pulse count time.
Pulse Count Time
120 Second
Press OK to SAVE
2) Use the [↑] and [↓] keys to set the time required.
Valid entries are 0 – 255 seconds.
3) Use the [→] key to toggle to cursor and set the
multiplier in seconds, minutes or hours using the
[↑] and [↓] keys.
4) Press [OK] to save and exit or press [MENU] to exit
without saving.
7-8
Input Programming
MENU 3-1-4
1
2
0
Seconds
Multiplier
Seconds, Minutes or Hours
Zn1
U N D E R S TA N D I N G D O O R A S S I G N M E N T
Door Assignments are used to link Readers, Users and
Outputs together to allow you to operate a door strike
when a user token is presented to a given reader. To do this
you need to create a door assignment and assign the user,
the reader and the output to the same door assignment.
Users
A user can belong to multiple Door Assignments.
Outputs
An output can only belong to 1 Door Assignment.
Reader
A reader can belong to only 1 Door Assignment.
Door Assignment
There are 16 different door assignments.
Door Assignment Example
1) To set up a door assignment you need to select an
unused Door Assignment number from 1 to 16, in
this example we will assume the Door Assignment
number to be 5.
2) Under user properties assign the users who you
wish to have access to Door Assignment 5.
Remember that you are able to assign users to
more than one Door Assignment.
3) Now select the output that will be used to operate
the door strike and assign it to Door Assignment 5.
You also need to set the output type to Door and
the polarity to one shot low with a time of how
long you would like the strike to operate. Generally
a strike would be operated for 5 seconds.
4) Assign the Reader under Keypads and Reader
properties to Door Assignment 5.
When a user who belongs to Door Assignment 5 presents
their token to the reader that is assigned to Door
Assignment 5, the assigned output will operate releasing
the door strike.
A reader can belong not only to a Door Assignment but
also to an Area if arming and disarming is required from
the reader.
If a user presents their token to an reader that has an
area assigned, then the user Door Assignment and Area
Permissions are both checked. If the area is armed and the
user belongs to the same area as the Reader and the same
Door Assignment, the system will disarm and allow access.
If the user does not belong to the same area as the reader
but the Door Assignment match, then door access will
only be available to that user if the area is disarmed.
When using the same reader for door access as well as
arming, you need to select the reader badging option
MENU 6-1-4 — General Options. Badging requires that
you present your token 3 times in succession within 5
seconds to arm the system.
Bosch Security Systems 10/22 BLCC615I
Advertisement
Chapters
Table of Contents
